 |
|
|
|
|
 |
 |
 |
|
|
 |
Two jaw chucks for holding irregular, square or rectangular parts. Large jaw stroke versions are also available. |
|||
 |
Three jaw wedge chucks in open and close centre versions. |
|||
 |
Quick-Change wedge bar chucks for high gripping force, good repeatability and the ability to change the gripping jaws quickly. |
|||
 |
Pneumatic front-end chucks which do not require a drawtube allowing the full use of the spindle bore. | |||
 |
Combination 2 / 3 jaws chucks to save the time spent swapping between 2 jaw and 3 jaw chucks. | |||
 |
Indexing chucks with 45°, 90° or 120° indexing. Ideal for turning valve bodies, Tee pieces, elbows and similar parts in one operation. Click the picture for more details on how an index chuck works. | |||
 |
Cylinders to operate the chucks. These can be pneumatically or hydraulically powered and optionally combined with a high-low clamping system. Double acting cylinders offer the ability to provide two clamping sequences. | |||
 |
In addition, Thame can supply adapter plates, drawbars, drawtubes, threaded connectors and adapters. Thame also offer a fitting service by our trained engineers to fit your workholding equipment. Click the picture to see a schematic layout of a typical spindle assembly. | |||
 |
 |
 |
|
|
