A Thame designed special jaw with carbide inserts.

These inserts obviate the need for heat treatment and are easy and cheap to replace when the edges become dull after heavy usage.

This two-jaw set is for an indexing chuck.

A Thame designed clamping solution for the machining of a bearing casing.

The bottom jaw is fixed to the chuck face giving a reference point. The top jaw pivots as well as clamps. This takes up any inaccuracies in the casting and ensures proper clamping.

Thame designed special hard jaws and backstop assembly for an automotive component.

These are mounted on a fully sealed, pull-back chuck preferred by the automotive industry.

Thame supplied the chuck, drawtube and clamping cylinder to make up a complete turnkey package.

Thame designed and manufactured special hard jaw, chuck face mounted backstop and orientation nest; used by a high volume automotive component manufacturer in an automated manufacturing cell.

Thame have also manufactured and supplied pick and place jaws for the robot load and unload of these components.